Capacity max. 12 t
For testing pul-lifts, lever hoists, chain blocks, wire rope pullers as well as other lifting equipment after repair or inspection.
Testing of hoisting equipment
The lifting unit is placed between upper and lower shackle, the chain is tensioned against the oil cushion of the partly advanced piston of the hydraulic cylinder. The applied force can be read at the pressure gauge.
Testing of the hoist brake
For a functional test of the hoist brake the hand pump may be used to apply a counter pressure and thus increase the pulling force after a general test.
Frequent use
For frequent testing, the hand pump may be replaced by a low-cost air hydraulic (model PAY-6) or electric pump (model PY-04/2/5/2 M).
Pressure gauge
To read pulling forces more easily, the test rig is equipped with two high-quality pressure gauges.
Quick couplers allow an easy replacement of pressure gauges.
Pressure gauge 1 for small test items: model: GGY-1005, display: 0-160 bar, O 100 mm, Kl. 1.0 %
Pressure gauge 2 for big test items: model: GGY-1003, display: 0-400 bar, O 100 mm, Kl. 1.0 %
Mounted hollow cylinder model YCS-21/150
Single-acting, with spring return
- Chromium-molybdenum steel, heat-treated with bronze bearings.
- Pressure-/pulling force: 120 kN (12 t).
- Operating pressure: 0 – 400 bar.
- Center hole O: 27 mm.
Mounted hydraulic hand pump model HPS-2/0,7A
Two-stage, with quick action
- Operating pressure: 0 – 400 bar.
- Reservoir: 0.7 l.
- Fine-adjustment pressure relief valve.
Features
- Fully welded, low-strain press-frame.
- Upper and lower hook suspension by means of shackles, incl. two 5 tons pull-rings for smaller test units.
- Lateral pump table.
- Infinite adjustment of the pulling force.
- Chart for easy determination of test force.
- Removable lower suspension e.g. for testing of plate clamps.
- Base pre-drilled for mounting.
- High-quality hydraulic components.
- Hollow cylinder made from chromium-molybdenum steel, heat-treated, inside and outside with dirt wipers.
- Long cylinder stroke of 150 mm, piston hard chromium-plated with bronze bearings.
- High-strength threaded bar M27.
- Two-stage quick action hand pump.
- Fine-adjustment pressure valve.
DOWNLOAD:
Brochure
Operating Instructions
Info
The test rigs are delivered complete and ready to use.
Technical data Hydraulic test rig for hoisting equipment RPYS-1215:
| Model | EAN-No. |
|---|---|
| 4025092* | |
| RPYS-1215 | *157469 |